Key Steel Cold Drawn Flat C45+C (SS2190)
Key steel is used traditionally for keyed joints which couple a rotating machine element with an axle. The base steel in the product is C45 +C which in cold-drawn execution is standardised in
SS-EN 10277-2. However, as regards mechanical properties, the correspondence is not exact and the key steel stocked by Tibnor has a minimum tensile strength of 600 MPa for all dimensions. Key steels are standardised in SS 212190 which is still valid since an SS-EN standard is currently lacking.
Key steel is characterised by very good tolerances, considerably better than what is normally stipulated for cold-drawn flats. The width tolerance is h9 according to the definition in ISO 286 - 2 while the corresponding tolerance range for thickness is h9 or h11. According to SS-EN 10278, h11 is the standardised tolerance for both width and thickness of cold-drawn flats. SS 212190 prescribes that key-steel bars shall have rounded or chamfered corners. Straightness is good and the maximum height of arc is 0.001 times bar length which is usually 3 m. In other words, the height of arc shall be at most 3 mm. Furthermore, SS 212190 stipulates that for a local reference length of 400 mm, the height of arc must always be below 0,8 mm.
As well as keyed joints, key steel may find application for other machine elements where the tight tolerances can be used to advantage.